Dremel Multi-Max MM20 and MM40 Press Release

Dremel Multi-Max MM20 Fact Sheet      Dremel Multi-Max MM20 Applications

Dremel Multi-Max MM20 Downloadable Images

Dremel Multi-Max MM40 Fact Sheet      Dremel Multi-Max MM40 Applications

Dremel Multi-Max MM40 Project Overview      Dremel Multi-Max MM40 Downloadable Images

PDF Version

Dremel^® Multi-Max™ MM20 Oscillating Tool System
Project Overview

Regrout Shower/Bath
Bathroom

Tools Needed

• Dremel Multi-Max MM20 Oscillating Tool

Accessories

• MM501 1/16-Inch Carbide Grout Blade
• MM500 1/8-Inch Carbide Grout Blade

Additional Materials

• Painter’s tape
• Dust brush
• Grout

Project Steps

1. Insert MM500 or MM501 Carbide Grout Blade into the tool, depending on the width of your grout lines, tighten the screw with the Allen wrench to secure the screw within the holder.
2. To protect your shower/bath area, we recommend linking the edge with painter’s tape before you begin work with your Dremel tool. You may also consider taping the tile for added protection.
3. Set the tool to medium to high speed and slowly guide the blade into the grout.
4. In smooth, even motions, push tool along the grout line to begin removal. Depending on how hard the grout is, more than one pass may be required.
5. If needed, rotate the blade to get into tight corners – remember to unplug the tool before changing the blade.
6. Keep the blade parallel to whatever ledge you’re working with, allowing the tool to meet the wall at a right angle.
7. To avoid scratching, do not allow it to rest on any ledges.
8. To control plunge depth, use the carbide grit line on the blade as an indicator. Do not plunge beyond grit line to prevent harming the backer board.
9. When finished, dust off edges and remove tape.
10. Regrout floor following floor preparation instructions supplied by grout manufacturer.

# # #

Editor’s Note: Dremel^® is a registered brand name and is used as an adjective to describe the products made by the Dremel brand.

Contacts: